2 posts / 0 new
Last post
Last seen: 1 year 5 months ago
Joined: 03/27/2016 - 19:47

Ok so I got the car running and began making some edits. The Nissan 350z/g35 uses a oil pressure switch to trigger a light and not a pressure sensor. The jumper harness says that c2-18 is oil pressure. So if I hook up the signal wire from this pin to the signal pin on an AEM 150-psig sensor and hook the sensor to 5v and sensor ground then I should see true oil pressure? Ive tried to look this up everywhere with no luck. Thanks!  

Last seen: 5 hours 57 min ago
Joined: 06/06/2014 - 09:31
That's correct. 

That's correct. yes